Sears 721.37060700 Manual page 8

4. DISASSEMBLY
4. Head Cover replacement.
1) Rotate the two cover retainers to unlock the
agitator cover.
2) Press in on the two tabs and rotate the agitator
cover up and off.
3) Remove the 10 screws and disconnect
receptacle with 3 pins and then disassemble
the Head Cover Assembly.
Note : Placement of small screws 3 x 8.
4) To reinstall the Head Cover reverse the steps
above.
5. PCB ASSEMBLY DISPLAY
1> LED PCB Assembly Display replacement.
2> Power PCB Assembly Display replacement
Connector
3> Height Adjustment PCB Assembly Display
- 8 -
REPLACEMENT
Power LED PCB
Assembly
LED PCB
Assembly
1) Remove the 1 screw and remove the
connector as shown.
Connector
1) Remove the 2 screws
and remove the
connector as shown.
Connector
replacement
1) Remove the 2
screws and remove
the connector as
shown.
Connector
MODEL 721.37060700
Height Adjustment
LED PCB Assembly