Table of Contents
Advertisement
4. DISASSEMBLY
2) Remove the Crevice tool and D / Brush.
3) Remove the Holder Accessory as shown.
4) To reinstall the Holder Accessory reverse the
steps above.
18.Handle Assembly replacement
1) Make sure the vacuum cleaner is locked in
the upright position and on a flat, stable
surface.
2) Press the wand release button on the carry
handle and tilt the wand handle forward.
3) Lift the wand out and up.
4) Press the release button
on the bottom of the
handle and pull the Pipe
Assembly straight out of
the handle.
5) Remove the hose assembly by pressing the
two release button on the Hose connector.
6) To reinstall the Handle Assembly reverse
the steps above.
- 14 -
MODEL 721.37060700
Advertisement
Table of Contents
