Table of Contents
Advertisement
3. DISPLAY LED
POWER ON/OFF
1. Plug the power cord into a proper outlet.
2. Press the ON/OFF button.
The Power indicator will light and
the main motor will run.
POWER LEVEL SELECTOR
1. Press the power button to select the power
level. Pressing the button repeatedly will
cycle through the power levels.
Recommended settings:
Lo: drapes, hard surfaces
Med: furniture, upholstery, area rugs
Hi: shag carpet, long pile, etc.
POWER
AGITATOR ON/OFF
4. For bare floors, press the Carpet/Floor
button to turn off the agitator.
NOTE: The agitator will not run with the handle
in the upright position.
When vacuuming, if the agitator is not running
at full speed due to an obstruction, in the agitator
area, the agitator "ON/OFF" LED will begin a
series of three flashes followed by a pause.
To correct problem: Turn off and unplug vacuum
cleaner, then remove obstruction from agitator.
ADJUSTING THE PILE HEIGHT
Press the right foot pedal to adjust the pile
height. Each press will lower or raise the agitator
one notch.
ON
The LED indicator will light for each setting to
OFF
show what is selected.
Suggested pile height settings:
You may need to raise the height to make
some jobs easier, such as vacuuming scatter
Lo
Med
Hi
rugs and longer pile rugs.
Recommended settings:
Carpet
XLO very low pile, bare floors
Floor
L short to medium pile
M medium to long pile
H shag carpet, long pile, scatter rugs
HEIGHT ADJUSTMENT
Attention: Special care is required when
vacuuming certain types of carpet or flooring.
Always check the carpet or floor covering
manufacturer's recommended cleaning
instructions before vacuuming.
- 5 -
MODEL 721.37060700
Advertisement
Table of Contents
