Maintenance And Care - Sears 721.37060700 Manual

5. MAINTENANCE AND CARE

IMPORTANT :
- Always unplug the power cord from electrical
outlet before performing any service on
vacuum cleaner.
- Frequently check the agitator brush area
for hair, string, and lint buildup. If buildup
becomes excessive, use the following
procedure to remove buildup and clogs.
1. Remove the Agitator Brush
1) Unplug the vacuum cleaner. Press the left
foot pedal to release the handle. Lower the
handle until the vacuum cleaner is lying flat
on the floor.
2) Turn the vacuum cleaner over, so that the
agitator is facing up.
3) Rotate the two cover retainers
to unlock the agitator cover.
4) Press in on the two tabs and rotate
the agitator cover up and off.
5) Carefully remove any accumulated string,
hair, etc. from the agitator and the agitator
area.
To reinstall the cover, hook the front edge of the
cover into place, rotate it down until the tabs clip
into place, then turn the retainers to the locked
position.
IMPORTANT :
- Always unplug the power cord from electrical
outlet before performing any service on
vacuum cleaner.
- Frequently check the agitator brush area
for hair, string, and lint buildup. If buildup
becomes excessive, use the following
procedure to remove buildup and clogs.
2. Replace the Agitator Belt.
1) To replace the Agitator Belt, you must
remove the Agitator.
2) Lift the agitator straight out.
3) Unhook the old belt from the
drive pulley. Make sure no
pieces of the broken belt are
trapped in the agitator or
drive pulley area.
4) Hook the new belt
over drive pulley.
f.
5) Fit the belt end of the agitator through the belt,
making sure the belt is aligned with the pulley
section of the agitator.
6) Lower the agitator into place,
making sure the oval shaped
tabs fit into the indents on the
vacuum cleaner.
7) Reinstall the agitator brush as described
above.
- 15 -
MODEL 721.37060700
.