T
S
ERMINAL
ETUP
Smart Battery
WARNING
WARNING
NOTE
Smart Battery
NOTE
26
V
X
5
/V
X
6
I
XX
XX
NSTALLATION
4
Plug the AC power cord into a wall outlet or powered surge protector.
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
Disconnecting the power during a transaction may cause transaction data files
not yet stored in terminal memory to be lost.
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
When the terminal has power, the terminal lights are activated and the green LED
indicator remains lit.
If an application is loaded in the terminal, it starts after the initial VeriFone
copyright screen and usually displays a unique copyright screen. If no application
is loaded in the terminal,
VeriFone copyright screen.
x
The V
6xx wireless terminal uses an Li-ion smart battery (see
Documentation
for ordering information). The internal logic of the smart battery
prevents both overcharging and undercharging (a fault condition in which the
battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
x
The V
6xx terminal will operate on battery power or on power pack power. The
smart battery charger in the terminal will be active whenever the power pack is
connected.
The following are features of the smart battery:
•
Two Li-ion cells
•
A fuel gauge module that
•
monitors state of charge (voltage and current),
•
communicates with the terminal (charge parameters and status to indicate
full discharge),
•
determines full charge capacity (on charge cycle and uninterrupted
discharge cycle), and
•
automatically shuts down when cell voltage is extremely low.
•
A safety circuit that
•
prevents cell damage from overcharge, over-discharge, or overheating
G
UIDE
appears on screen after the initial
DOWNLOAD NEEDED
Accessories and