•
activates when the battery is left in an unused terminal for extended
periods, and
•
resets when battery voltage reaches a preset threshold during the charge
cycle.
NOTE
Conserve battery power by turning the V
terminal is not to be used for several days, remove the battery from the terminal
as it continues to discharge even when the terminal is turned off.
Installation
x
The V
6xx smart battery fits in a slot on the back of the V
in
Figure
so that there is only one way to insert the battery.
Figure 20
Removal
To remove the V
and pull the smart battery from its slot.
Figure 21
Charging
After unpacking your V
pack to the unit for 6 hours.
It is also recommended that the smart battery receive a periodic full discharge. To
ensure a full discharge, use the unit until the battery is fully drained.
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery. The battery must then be recharged to restore operation.
20. The locking tab clicks when the battery is in place. The slot is keyed,
Install the Smart Battery
x
6xx smart battery, press the locking tab at the top of the battery
Detaching the Smart Battery from the V
x
6xx terminal, install the battery and connect the power
x
6xx terminal off when not in use. If the
x
6xx terminal, as shown
x
6xx Terminal
X
X
V
5
/V
6
I
XX
XX
NSTALLATION
T
S
ERMINAL
ETUP
Smart Battery
27
G
UIDE