Power Port; Smart Battery - VeriFone Omni 3600 Installation Manual

Power Port

NOTE
WARNING

Smart Battery

•
A SAM (security access module) access door, underneath the battery
(Figure 9). The Omni 3600 terminal contains three micromodule-sized SAM
(MSAM) cardholders to support multiple stored-value card programs or other
merchant cards
The Omni 3600 terminal is equipped with a tamper-evident label (on a screw hole
on the case bottom).
On the back of the Omni 3600 is one port—the power port. Use this port to
connect the Omni 3600 to the power pack to recharge the battery through the unit
Connect Power Pack
To connect the Omni 3600 terminal to power:
1
Insert the round barrel connector
the terminal.
2
Insert the power cable into the power pack.
3
Plug the power pack into a wall outlet or surge protector.
Install a power surge protector to protect against possible damage caused by
lightning strikes and electrical surges.
Figure 3 Connect Omni 3600 Terminal Power Pack
Do not plug the power pack into an outdoor outlet.
The Omni 3600 wireless terminal uses an Li-ion smart battery (see
and Documentation for ordering information). The internal logic of the smart
battery prevents both overcharging and undercharging (a fault condition in which
the battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
(Figure 3) into the power port on the back of
O 3600 I
MNI
O 3600 T
MNI ERMINAL
Smart Battery
Accessories
11
G
NSTALLATION UIDE