Installing the
x
V
610 wireless terminals use Li-ion smart batteries (see
x
V
610 Smart
Documentation
Battery
prevents both overcharging and undercharging (a fault condition in which the
battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
The V
NOTE
smart battery charger in the terminal will be active whenever the power pack is
connected.
The following are features of the smart battery:
•
•
•
Conserve battery power by turning the V
NOTE
terminal is not to be used for several days, remove the battery from the terminal
as it continues to discharge even when the terminal is turned off.
Installation
The V
in
Figure
so that there is only one way to insert the battery.
Figure 29
for ordering information). The internal logic of the smart battery
x
610 terminal will operate on battery power or on power pack power. The
Two Li-ion cells
A "fuel gauge" module that
•
monitors state of charge (voltage and percentage of capacity),
•
communicates with the terminal (charge parameters and status),
•
determines full charge capacity (on charge cycle and uninterrupted
discharge cycle), and
•
automatically shuts down when cell voltage is extremely low.
A safety circuit that
•
prevents cell damage from overcharge, over-discharge, or overheating
•
activates when the battery is left in an unused terminal for extended
periods.
x
610 smart battery fits in a slot on the back of the V
29. The locking tab clicks when the battery is in place. The slot is keyed,
Install the Smart Battery
Installing the V
Accessories and
x
610 terminal off when not in use. If the
x
610 terminal, as shown
O
5
V
5
/V
610 I
X
X
MNI
XXX AND
XX
T
S
ERMINAL
ETUP
x
610 Smart Battery
33
G
NSTALLATION
UIDE