Power Port; Smart Battery - VeriFone Omni 3600 Reference Manual

The Omni 3600 terminal is equipped with a tamper-evident label (on a screw hole
on the case bottom).

Power Port

On the back of the Omni 3600 is one port—the power port. Use this port to
connect the Omni 3600 to the power pack to recharge the battery through the unit
Connect Power Pack
To connect the Omni 3600 terminal to power:
1
2
3
NOTE
Install a power surge protector to protect against possible damage caused by
lightning strikes and electrical surges.
Figure 3
WARNING
Do not plug the power pack into an outdoor outlet.

Smart Battery

The Omni 3600 wireless terminal uses an Li-ion smart battery (see
and Documentation
battery prevents both overcharging and undercharging (a fault condition in which
the battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
CAUTION
Note that a new Li-ion battery's full performance is achieved only after
two or three complete charge and discharge cycles.
On initial use, allow the Omni 3600 smart battery to charge 4 hours,
then fully discharge during normal operation, to ensure reliable battery
operation.
Insert the round barrel connector
the terminal.
Insert the power cable into the power pack.
Plug the power pack into a wall outlet or surge protector.
Connect Omni 3600 Terminal Power Pack
for ordering information). The internal logic of the smart
O 3600 T
MNI ERMINAL AND
(Figure 3) into the power port on the back of
O
MNI
O 3600 B I
MNI ASE NSTALLATION
Omni 3600 Terminal
Accessories
3600 R M
EFERENCE ANUAL
11