Connection Through The <Usb Device> Terminal; Connecting To A Computer In The Usb Device Mode - Panasonic Varicam 35 Operating Manual

Chapter 9 Other Useful Functions — Connection through the <USB DEVICE> terminal
Connection through the <USB DEVICE> terminal

Connecting to a computer in the USB device mode

Connecting to a computer
1
Connect the USB cable to the <USB DEVICE> terminal (device). (Fig. 1)
2
Set the [MENU] → [SYSTEM SETTINGS] → [INFORMATION] to [USB].
For details, refer to "Setting menu basic operations" (page 102).
During USB connection, [USB DEVICE CONNECTED] is displayed in the center of the control panel.
If it is not connected properly, [USB DEVICE DISCONNECTED] is displayed.
3
Exit the USB device mode.
There are following two methods:
f Turn the power switch of the camera to <OFF>.
f Press the <HOME> button.
@
NOTE
t The USB 2.0 cable is not supplied with the camera. Prepare a commercial USB 2.0 cable (double-shielded for noise suppression).
t A USB connection cable of up to 5 m is supported, however, a cable of 3 m or shorter is recommended as preferable.
t When the camera is operating in the USB device mode, no camera shooting, recording/playback operation or clip thumbnail operation is allowed.
t When the camera is operating in the USB device mode, the P2 card remaining capacity and status are not displayed. Also, video/audio cannot be
output or displayed.
Fig. 1
– 99 –