Table of Contents
Advertisement
Chapter 11 Network Connection — Connecting the remote operation panel (AK-HRP200G)
f Digital extender display <D.EXT>: Disabled
r When the [MENU] → [CAMERA SETTINGS] → [Enhanced] → [Enhanced SW] is set to [OFF]
Following buttons are disabled in addition to limitation when [Enhanced SW] is set to [ON].
f Matrix button <MATRIX>
f Skin tone detail button <SKINDTL>
f Detail off button <DTL OFF>
f Detail volume <DTL>
f RGain volume <GAIN R>
f BGain volume <GAIN B>
f RFlare/pedestal volume <FLARE/PED R>
f BFlare/pedestal volume <FLARE/PED B>
f Master pedestal volume <M.PED>
About adjusted value display area (4 digits)
Zoom, focus, and auto focus are not supported.
When the VFR is set to [ON], it is displayed as [***P] (*** is the frame rate value).
When the VFR is set to [OFF], it is displayed as [FroF].
When the setting of the camera is set to [Native ISO] or [ISO], it is displayed as [iSo].
@
NOTE
t To connect the camera and AK-HRP200G directly, use a crossover LAN cable.
t For details, refer to the Operating Instructions of AK-HRP200G.
t The following information is required to connect to AK-HRP200G.
- User account name
- Password
- IP address
- Port number: 49152
t For AK-HRP200G, use Ver4.01.00 or later versions.
t For details on the operations of ROP setup software application, refer to the Operating Instructions of AK-HRP200G.
t For the ROP setup software application, use Ver3.0.0.0 or later versions.
– 140 –
Advertisement
Table of Contents
