Installing Dc Power Modules - Nortel 8600 Quick Start Manual

Installing DC power modules

Install the power supply that you ordered with your chassis in the leftmost
bay.
28)) The 8006 and 8010 chassis have three power supply bays, which are
numbered 1, 2, and 3 left to right as viewed from the front of the chassis.
The DC power supply shipment contains several hardware accessories.
Use the following checklist to verify the contents of the 8004DC shipping
container.
Table 2
DC power supply shipping accessories: 8004DC
Check
Use the following checklist to verify the contents of the 8005DC shipping
container.
Table 3
DC power supply shipping accessories: 8005DC
Check
Copyright © 2006 , Nortel Networks
.
(Figure 14 "Installing a power supply in an 8010co chassis" (page
Accessory
2 two-hole crimp
lug terminals with
attached tubing
(8004)
1 one-hole crimp
lug terminal with
attached tubing
5 nuts
5 lock washers
1 washer
Accessory
3 two-hole crimp
lug terminals with
attached tubing
6 nuts
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 01.01 Standard
4.1 21 December 2006
Installing a power module 29
Use to
Connect the positive
and negative power
inputs
Connect the ground
stud
Connect all leads
Connect all leads
Connect the ground
stud
Use to
Connect the positive
and negative power
inputs
Connect all leads
Nortel Networks Confidential