Nortel 8600 Quick Start Manual page 19

Installing the 8010co chassis in a Hendry rack
Use the 12 hex-head screws and a nutdriver to install the chassis in a
Hendry rack.
To install the 8010co chassis in a Hendry rack:
Step
1
2
3
4
5
Copyright © 2006 , Nortel Networks
.
Action
Place the installation shelf at the bottom of the rack.
Holding the installation shelf in position, align the shelf's mounting
rail with two holes on each side of the vertical rack support.
Insert a hex-head screw through each installation shelf mounting
hole and into the corresponding hole in the rack
the shelf in a Hendry rack: 8010co chassis" (page
Figure 6
Installing the shelf in a Hendry rack: 8010co chassis
Tighten each screw with a nutdriver.
Using a Phillips screwdriver, remove the 5 screws securing each of
the two mounting rails to the 8010co chassis
the mounting rails from the 8010co chassis" (page
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 01.01 Standard
4.1 21 December 2006
Installing the 8010co chassis into the rack 19
(Figure 7 "Removing
(Figure 6 "Installing
19)).
20)).
Nortel Networks Confidential