Connecting The I2022- Manual-Install - Nortel i2022 Series User Manual

Isdn teleset
Table of Contents

Advertisement

1. Assemble the i2022
NOTE: Make sure the logo plate is installed
2. Verify the PS1/PS2 switch located on the Interface Module is in the PS2 position. See page 6 for further
information on setting the PS1/PS2 switch.
3. Verify the Terminating Resistor (TR) switch is set correctly. See page 8 for further information on setting the TR switch.
4. Connect one end of the eight-pin mounting cord to the ISDN Line-In jack on the bottom of the Teleset. Connect
the other end of the cord to the S/T jack on your NT1 or ISDN telephone wall jack.
5. Remove the protective film on the display.
6. Label and install the designation card
Manually Choose the Switch Type
NOTE: Your Teleset has a factory default setting of "AUTO" which adjusts to the switch type. An incorrect switch
type results in a warning message from the Teleset. The correct switch type, as detected by the Teleset, is
displayed as a prompt to change your switch selection.
Manually Entering the SPID
The i2022 supports up to two SPIDs. The two SPIDs are designated
SPID 1 and SPID 2. Both SPIDs can be configured to meet a variety of applications. See Table 4.
Voice Only
Voice with alternate Analog Port on Call Appearance 1
Voice with alternate Data on Call Appearance 1
Voice with alternate Analog Port and Data on Call Appearance 1
Voice with simultaneous Data
Voice with simultaneous Analog Port
Voice with simultaneous, alternate Data and Analog Port
Voice with alternate analog port and simultaneous Data
Voice with alternate Data and simultaneous analog port
NOTE: POTS is the Analog Port.
To change either or both SPIDS:
1. Press MENU, MORE, MORE, Config, MORE, MORE, SPID.
2. Select the SPID you wish to change.
3. Press Change if you want to edit the SPID. Pressing Change will not erase the displayed SPID until the new SPID is
entered from the keypad. Press Clear if you want to erase the existing SPID.
[Enter the Phone SPID]
SPID1 = 84755547360101
Auto Bkspc Save
MORE is flashing

Connecting the I2022- Manual-install

APPLICATION
i2022 ISDN Teleset
Voice & <option>
Voice & POTS
Voice & Data
Voice & (P+D)
Voice & <option>
Voice & <option>
Voice & <option>
Voice & POTS
Voice & Data
Table 4
16
SPID 1
SPID 2
NULL
NULL
NULL
NULL
Data
POTS
Data & POTS
Data
POTS

Advertisement

Table of Contents
loading

Table of Contents