Table of Contents
Advertisement
Manually Programming Call Appearances
Take a look at the layout of the Line and Call Appearance keys. These (32) keys are located on the far-right hand side of
the phone. The upper-left-hand key is the default or primary key. This key must remain a Call Appearance key. All of the
other 31 keys are programmable.
It is important to check with your system administrator to see how your Teleset is provisioned at the switch. You will have
at least one Directory Number (DN) and at least one, or more, Call Appearances (CA). Both the Directory Numbers and
the Call Appearances must mirror the provisioning at the switch.
To configure the DN/CA:
1. Press MENU, MORE, MORE, Config, MORE, MORE, DN/CA. The following is displayed:
The first three programmable keys should be lit. These three keys are the default CA keys.
NOTE The first three CA keys lit is default. If the first three CA keys are not lit, or there is a DN displayed, the
Teleset is not in the default condition.
1
9
17
25
2
10
18
26
3
11
19
27
4
12
20
28
5
13
21
29
6
14
22
30
7
15
23
31
8
16
24
32
In our example, we will enter DN 847-555-4736 with two CAs, DN 847-555-1234 with 4 CAs, and DN 847-555-4321 with
one CA. The first two DNs will have a Bearer Service of Speech and the third will have a Bearer Service of Audio.
To enter the first DN, press Change, and enter the first DN. Enter the DN in a seven-digit format (no area code).
i2022 ISDN Teleset
18
Advertisement
Table of Contents
