Configuring The System Using The Setup Utility - Nortel NN46205-310 Quick Start Manual

Configuring the system using the setup utility
Use the setup utility for the initial configuration of the switch. The setup
utility uses a series of questions to guide you through the configuration
process.
ATTENTION
Answer each question, or accept the default by pressing Enter. Each question
includes the default value in brackets and the acceptable parameter options in
parenthesis.
Procedure steps
Step
1
2
3
4
5
Copyright © 2008 Nortel Networks
.

Configuring the system using the setup utility 65

Action
Power up the system.
Connect through the console and logon as a default user using
the following command:
install
ATTENTION
You must connect to the master CPU to use the install script.After
running the setup utility, remember to reboot the switch.
A Welcome to the Ethernet Routing Switch 8000 Setup Utility
message appears stating you are starting initial configuration of
the switch. The data is stored in the /flash/boot.cfg and runtime
configuration flash/config.config files.
If you want to continue, type
y.
Follow the setup utility prompts.
See "Procedure job aid: Setup Utility prompt descriptions" (page
66).
Restart the switch.
ATTENTION
You can use a default password to log on if the switch reboots
without any previously configured password, and the high secure
(hsecure) mode is enabled. however, you will be prompted to change
the password
For more information about the secure mode, see Security,
NN46205-601.
Nortel Ethernet Routing Switch 8600
Quick Start
NN46205-310 02.01 Standard
30 May 2008
--End--