Table of Contents
Advertisement
36 Chapter 4 Power supply installation
3
What is next?
Do one of the following:
IF
this is an AC-powered server
this is a DC-powered server
DC wire gauge tables
Introduction
The tables in this section specify the DC power feed wire requirements.
Cabinet and module DC feed recommended wire gauge specifications
Length
0-30 m (100 ft)
0-45 m (150 ft)
0-75 m (250 ft)
0-135 m (450 ft)
Notes:
1.
The cabinet and module ground wire specification is #10 AWG insulated green safety ground wire.
2.
The cabinet conduit can be 19.1 mm (0.75-in.) or 31.8 mm (1.25-in.), and must be insulated
from the cabinet ground.
Copyright © 2007, Nortel Networks
.
Secure the power supply module to the chassis with two
thumbscrews at the corners of the power supply faceplate.
#10 AWG
#8 AWG
yes
yes
no
yes
no
no
no
no
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
—End—
THEN
continue with
"Installing the server"
(page 43)
on page
server" (page
43).
continue with
"DC wire gauge tables"
(page
36).
Junction
box #4
#6 AWG
AWG
yes
yes
yes
yes
yes
yes
no
yes
"Installing the
Junction
box #4
AWG
yes
yes
yes
yes
Nortel Networks Confidential
Advertisement
Table of Contents
