Direct Transmission - Panasonic DP-1810F Operating Instructions Manual

Direct Transmission

If your machine's memory is full or you wish to send the document(s) immediately, use Direct Transmission.
Manual Number Dialling (Direct Transmission)
To dial the telephone number manually, follow the steps below.
Make sure that the FAX/EMAIL lamp is ON. If not, press
1a
Place original(s) face up on the ADF.
or
1b
Place a book or an original face down on the Platen Glass.
1
Press
2
2
M2/ MEM XMT
3
Enter a telephone number from the keypad.
Ex:
5 5 5 1 2 3 4
4
Your machine starts dialling the telephone number.
NOTE
1. If you need a special access number to get an outside line, dial it first then press
enter a pause (represented by a "-") before dialling the full number.
Ex: 9 PAUSE 5551234
2. If you are using Pulse dialling and you wish to change to Tone dialling in the middle of dialling,
press
The dialling mode will be changed from Pulse to Tone after dialling the digit "/".
Ex: 9 PAUSE * 5551234
3 To stop the transmission, press
The display shows:
COMMUNICATION STOP?
1:YES 2:NO
Press
the printout mode setting of the Communication Journal.
to select the original size.
ORIGINAL SIZE
Make sure that the lamp goes off.
(represented by a "/").
to stop the transmission. The Communication Journal will not print out regardless of
1
Sending Documents
to select the "FAX/EMAIL" mode.
ENTER STATION(S)
THEN PRESS START 00%
ENTER STATION
THEN PRESS START 00%
TEL. NO.
5551234❚
* DIALLING *
5551234
.
STOP
to
PAUSE
47