Nt6D70 Silc Line Card; Contents; Introduction - Nortel Circuit Card 311 Reference

NT6D70 SILC Line card

Contents

This section contains information on the following topics:
"Introduction" (page 373)
"Physical description" (page 375)
"Functional description" (page 375)

Introduction

The S/T Interface Line card (SILC) (NT6D70AA –48V North America,
NT6D70 BA –40 V International) provides eight S/T four-wire full-duplex
interfaces to connect ISDN BRI-compatible terminals over Digital Subscriber
Loops (DSLs) to the System. A description of the ISDN BRI feature is
contained in ISDN Basic Rate Interface: Installation and Configuration
(NN43001-318).
You can install this card in any IPE slot.
The S/T Interface Line cards (SILC) (NT6D70AA-48V North America,
NT6D70 BA -40 V International) provide eight S/T four-wire full duplex
interfaces that are used to connect ISDN BRI compatible terminals over
DSLs to the Meridian 1 system. A description of the ISDN BRI feature is
contained in ISDN Basic Rate Interface: Maintenance (NN43001-718).
The S/T Interface Line card (SILC) (NT6D70AA –48V North America,
NT6D70 BA –40 V International) provides eight S/T four-wire full-duplex
interfaces to connect ISDN BRI-compatible terminals over Digital Subscriber
Loops (DSLs) to the CS 1000 system.
Copyright © 2003-2008, Nortel Networks
.
Note: A maximum of four NT6D70 SILC cards are supported in a Media
Gateway and Media Gateway Expansion.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
373