Nortel Circuit Card 311 Reference page 818

818 NT8D41AA Serial Data Interface Paddle Board
Table 319
Serial port configuration parameters
Prompt Response
REQ CHG
TYPE CFN
IOTB YES
ADAN NEW TTY x
New PRT x
CDNO 1–16
DENS DDEN
xxx
USER
XSM Yes, (No)
Applications
The NT8D41AA Serial Data Interface paddle board is used to connect the
Meridian 1 switch to a variety of communications devices, printers, and
peripherals. Any RS-232-C compatible device can be connected to either of
the card's two serial ports.
The standard application for the paddle board is to connect the Meridian
1 switch to the system console. This can be either a direct connection
if the console is located near the switch, or through a modem for remote
maintenance.
Bell 103/212 compatible dumb modems are recommended to connect a
remote data terminal. If a smart modem (such as a Hayes modem) is
used, configure the modem for the dumb mode of operation (Command
Recognition OFF, Command Echo OFF) before connecting the modem
to the asynchronous port.
The serial data interface connectors on the paddle board are not RS-232-C
standard DB-25 connectors. The NT8D84AA interface cable is used to
adapt the paddle board to a non-standard pinout DB-9 connector (normally
located on the I/O panel). The NT8D93 cable is then used to connect the
non-standard DB-9 connector to a peripheral that uses a RS-232-C standard
DB-25 connector. See
Copyright © 2003-2008, Nortel Networks
.
Description
Change configuration.
Configuration type.
Change input/output devices.
Define a new system terminal (printer) port as device x, where x
= 0 to 15.
Use the SDI paddle board number to keep track of all ports.
Double density SDI paddle board.
Enter the user of port x. The values that can be entered depend on
the software being used. See the Software Input/Output Reference
— Administration (NN43001-611) for details.
Port is used for the system monitor.
Figure 269 "SDI paddle board cabling" (page
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
819).