Nortel Circuit Card 311 Reference page 748

748 NT8D15 E and M Trunk card
Figure 239
Signaling orientation for tandem connection between E and M and CO trunks
The information in this section describes the signaling and call control of E
and M Type I and II trunks. The call is terminated and the trunk released by
a disconnect message sent to the associated unit.
Figure 242 "Signaling orientation for tandem connection between E and M
and CO trunks" (page 752)
for a tandem connection between E and M and CO trunks.
The information in this section describes the signaling and call control of E
and M Type I and II trunks. The call is terminated and the trunk released by
a disconnect message sent to the associated unit.
orientation for tandem connection between E and M and CO trunks" (page
765)
E and M and CO trunks.
E and M Type I signaling
Figure 240 "E and M Type I signaling patterns - originating party release"
(page 750)
outgoing calls.
party release on a tandem connection" (page 751)
patterns on a tandem connection where the originating end is senderized
and the route is over a CO trunk (not applicable to CCSA).
Figure 243 "E and M Type I signaling patterns - originating party release"
(page 753)
outgoing calls.
party release on a tandem connection" (page 754)
patterns on a tandem connection where the originating end is senderized
and the route is over a CO/FX/WATS trunk (not applicable to CCSA).
Copyright © 2003-2008, Nortel Networks
.
shows the trunk signaling orientation for a tandem connection between
shows E and M Type I signaling patterns for incoming and
Figure 241 "E and M Type I signaling patterns - originating
shows E and M Type I signaling patterns for incoming and
Figure 244 "E and M Type I signaling patterns - originating
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 01.04 Standard
Release 5.0 23 May 2008
shows the E and M Trunk signaling orientation
Figure 247 "Signaling
shows Type I signaling
shows Type I signaling