Warning Statement For Norway And Sweden; Prevention Of Electrostatic Discharge Damage - Juniper 3800 Hardware Manual

Warning Statement for Norway and Sweden

Supported Platforms
Related
Documentation

Prevention of Electrostatic Discharge Damage

Supported Platforms
Copyright © 2015, Juniper Networks, Inc.
Definitions of Safety Warning Levels on page 61
Fire Safety Requirements on page 67
JSA1500, JSA3500, JSA5500, JSA7500
WARNING: The equipment must be connected to an earthed mains
socket-outlet.
Advarsel Apparatet skal kobles til en jordet stikkontakt.
Varning! Apparaten skall anslutas till jordat nätuttag.
General Safety Guidelines and Warnings on page 63
Definitions of Safety Warning Levels on page 61
Fire Safety Requirements on page 67
Qualified Personnel Warning on page 64
JSA1500, JSA3500, JSA5500, JSA7500
Device components that are shipped in antistatic bags are sensitive to damage from
static electricity. Some components can be impaired by voltages as low as 30 V. You
can easily generate potentially damaging static voltages whenever you handle plastic
or foam packing material or if you move components across plastic or carpets. Observe
the following guidelines to minimize the potential for electrostatic discharge (ESD)
damage, which can cause intermittent or complete component failures:
Always use an ESD grounding strap when you are handling components that are subject
to ESD damage, and make sure that it is in direct contact with your skin.
If a grounding strap is not available, hold the component in its antistatic bag (see
Figure 17 on page 66) in one hand and touch the exposed, bare metal of the device with
the other hand immediately before inserting the component into the device.
WARNING: For safety, periodically check the resistance value of the ESD
grounding strap. The measurement must be in the range 1 through
10 Mohms.
When handling any component that is subject to ESD damage and that is removed
from the device, make sure the equipment end of your ESD grounding strap is attached
to the ESD point on the chassis.
Chapter 16: General Safety Guidelines and Warnings
65