Figure 6: Jsa3800 Front Panel Leds; Table 12: Db-9 Console Connector Pinouts For The Jsa3800 Appliance - Juniper 3800 Hardware Manual

Juniper Secure Analytics 3800 Hardware Guide
26
When you turn on the power, the internal port uses two LEDs to indicate the LAN
connection status, as shown in

Figure 6: JSA3800 Front Panel LEDs

1— Information LED
2— LAN2 LED
3—LAN1 LED
Plug an RS-232 (DB-9 F/F) cable into the console port.
5.
Table 12 on page 26 describes the details of the DB-9 console port pinouts for the
JSA3800 appliance.

Table 12: DB-9 Console Connector Pinouts for the JSA3800 Appliance

Pin Signal
1 DCD
2 RxD
3 TxD Output
4 DTR Output
5 GND
6 DSR Input
7 RTS Output
8 CTS Input
9 RI
10 NC
Push the Power button on the front panel.
6.
The Power LED below the power button turns on.
Figure 6 on page 26.
4— Hard drive LED
5— Power LED
Description
Data Carrier Detect
Receive Data
Transmit Data
Data Terminal Ready
Chassis Ground
Data Set Ready
Request to Send
Clear to Send
Ring Indicator
Not Connected
Copyright © 2015, Juniper Networks, Inc.