Table of Contents
Advertisement
CHAPTER 15
Replacing Power System Components
Replacing an AC Power Supply on the JSA3800 Appliance
Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Replacing an AC Power Supply on the JSA3800 Appliance on page 55
Replacing AC Power Supply Cables on the JSA3800 Appliance on page 56
Replacing a DC Power Supply on the JSA3800 Appliance on page 56
Replacing DC Power Supply Cables on the JSA3800 Appliance on page 57
To replace an AC power supply:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the power cord from the power supply.
2.
Push the release tab of the power supply on the back panel of the chassis.
3.
Pull the power supply straight out of the chassis using the provided handle. Use one
4.
hand for support underneath the supply as you remove it.
Orient the replacement power supply.
5.
Using both hands, slide the replacement power supply straight into the chassis until
6.
the power supply is fully seated in the chassis slot. Make sure the tab on the power
supply clicks into place.
Attach the power cord to the power supply. If the power supply is correctly installed
7.
and functioning normally, the power supply powers up immediately.
Replacing AC Power Supply Cables on the JSA3800 Appliance on page 56
Replacing DC Power Supply Cables on the JSA3800 Appliance on page 57
Replacing a DC Power Supply on the JSA3800 Appliance on page 56
55
Advertisement
Table of Contents
Troubleshooting
