General Electrical Safety Guidelines And Warnings - Juniper 3800 Hardware Manual

Juniper Secure Analytics 3800 Hardware Guide

General Electrical Safety Guidelines and Warnings

Supported Platforms
90
JSA1500, JSA3500, JSA5500, JSA7500
WARNING: Certain ports on the device are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE, Issue 4) and require isolation from the exposed outside plant
(OSP) cabling. To protect against lightning surges and commercial power
disturbances, the intrabuilding ports must not be metallically connected to
interfaces that connect to the OSP or its wiring. The intrabuilding ports on
the device are suitable for connection to intrabuilding or unexposed wiring
or cabling only. The addition of primary protectors is not sufficient protection
for connecting these interfaces metallically to OSP wiring.
WARNING: The intrabuilding port(s) (40G DACS and USB ports) of the
equipment or subassembly must use shielded intrabuilding cabling or wiring
that is grounded at both ends.
WARNING: The intrabuilding port(s) (including the following ports, when
present: DAC, External Clock, Internal Clock, T1/E1, POE Ethernet) of the
equipment or subassembly must use shielded intrabuilding cabling or wiring
that is grounded at both ends.
CAUTION: Before removing or installing components of a device, attach an
electrostatic discharge (ESD) grounding strap to an ESD point and place the
other end of the strap around your bare wrist. Failure to use an ESD grounding
strap could result in damage to the device.
Install the device in compliance with the following local, national, and international
electrical codes:
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code.
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7.
Evaluated to the TN power system.
Canada—Canadian Electrical Code, Part 1, CSA C22.1.
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
Copyright © 2015, Juniper Networks, Inc.