Juniper 3800 Hardware Manual page 54

Juniper Secure Analytics 3800 Hardware Guide
Related
Documentation
38
WARNING: Before you perform the following procedure, ensure that power
is removed from the DC circuit. To ensure that all power is off, locate the
circuit breaker on the panel board that services the DC circuit, switch the
circuit breaker to the OFF position, and tape the switch handle of the circuit
breaker in the OFF position.
To connect the DC source power to the JSA3800 appliance:
Ensure that the input circuit breaker is open so that the voltage across the DC power
1.
source cable leads is 0 V, and so that the cable leads will not become active while
you are connecting DC power.
Connect the stripped and twisted wires to the wire clamps under the DC terminal
2.
screws on the back panel of the JSA3800 appliance.
NOTE: The red cable should be connected to the V+ terminal, and the
black cable should be connected to the V- terminal, respectively.
Use the terminal screws to secure the power source cables to the power feed on the
3.
JSA3800 appliance by attaching the twisted wires that are attached to the cables to
the appropriate terminals.
Attach the plastic safety cover.
4.
Connecting the JSA3800 Appliance to a Management Device on page 35
Installing the JSA3800 Appliance on page 25
Grounding the JSA3800 Appliance on page 33
Copyright © 2015, Juniper Networks, Inc.