IBM System x3650 Type 7979 Problem Determination And Service Manual page 32

Table 2. Switches 1 - 8
Switch
number Default value
8 Off
7 Off
6 Off
5 Off
4 Off
3 Off
2 Off
1 Off
Notes:
1. Before you change any switch settings or move any jumpers, turn off the server;
2. Any system-board switch or jumper blocks that are not shown in the illustrations
14
IBM System x3650 Type 7979 and 1914: Problem Determination and Service Guide
Switch
description
Reserved.
Remote Supervisor Adapter II SlimLine BIST. When this switch is toggled to On, it
causes the Remote Supervisor Adapter II SlimLine to execute the Built In Self Test
(BIST).
Power-on override. When this switch is toggled to On, it forces the power on,
overriding the power-on button.
Power-on password override. Changing the position of this switch bypasses the
power-on password check the next time the server is turned on and starts the
Configuration/Setup Utility program so that you can change or delete the power-on
password. You do not have to move the switch back to the default position after the
password is overridden.
Changing the position of this switch does not affect the administrator password check
if an administrator password is set.
See the User's Guide on the IBM System x Documentation CD for additional
information about the power-on password.
Force BMC update. When this switch is toggled to On, it causes an update of BMC
firmware from the diskette drive.
Force BMC reset. When this switch is toggled to On, it forces the BMC to reset.
Reserved.
Clear CMOS. When this switch is toggled to On, it clears the CMOS data, which
clears the power-on password.
then, disconnect all power cords and external cables. (Review the information in
"Safety" on page vii, "Installation guidelines" on page 87, and "Handling
static-sensitive devices" on page 89.)
in this document are reserved.