IBM System x3650 Type 7979 Problem Determination And Service Manual page 141

v After you replace the battery, you must reconfigure the server and reset the
system date and time.
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the new battery:
a. Hold the battery in a vertical orientation so that the smaller side is facing the
housing.
b. Place the battery into its socket, and press the battery toward the housing
until it snaps into place.
3. Reinstall any adapters that you removed.
4. Reconnect the internal cables that you disconnected.
5. Make sure that the riser-card assembly is fully seated in the connector on the
system board.
6. Install the cover (see "Installing the cover" on page 91).
7. Slide the server into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
Chapter 4. Removing and replacing server components
123