IBM System x3650 Type 7979 Problem Determination And Service Manual page 151

Installing the 2.5-inch-drive backplane
To install the replacement 2.5-inch-drive hard disk drive backplane, complete the
following steps.
2.5" hard disk
drive cage assembly
1. Align the replacement backplane cage assembly with the opening in the front of
the server.
2. Slide the backplane cage assembly into the front of the server until it clicks into
place. Make sure the release latches hold the backplane securely in place.
3. Connect the power and signal cables to the backplane.
4. Replace the fan bracket assembly (see "Installing the fan-bracket assembly" on
page 95).
5. Install the cover (see "Installing the cover" on page 91).
6. Slide the server into the rack.
7. Insert the hard disk drives into the bays.
8. Connect the cables and power cords.
9. Turn on all attached devices and the server.
Chapter 4. Removing and replacing server components
133