T
S
ERMINAL
ETUP
Install Paper Roll
Optional Swivel
Stand
Install Paper
Roll
14
I
G
NSTALLATION
UIDE
Figure 6
Pass-Through Connection
A pass-through telephone line connection can save the cost of an additional
dedicated or leased line, but there are several disadvantages to using a pass-
through connection:
•
Normal calls cannot be made while the terminal is processing a transaction, or
when a remote host computer is dialing in to the terminal.
•
Lifting the telephone handset during a transaction can disrupt the audible data
carrier signal and cause the terminal transaction to fail.
VeriFone produces an optional swivel stand for Omni 3200
Some terminals come with the swivel stand already attached, with two pre-
installed "pigtail" cables to allow convenient connection of the power cable and
telephone line cord without removing the swivel stand.
To set up a direct connection using the pigtail cable:
•
Insert the connector on one end of the telephone line cord into the modular
RJ-11 female jack on the end of the telephone line pigtail.
•
Insert the connector on the other end of the cord into a nearby RJ-11
telephone wall jack.
•
To configure a pass-through connection for a terminal with attached swivel
stand, the stand must be removed, then re-attached. The procedure for
removing and reattaching the swivel stand is described in the Omni 3200
3210
Stand Quick Installation Guide , (VPN - 22880).
SE
A fast, quiet thermal printer is built-in to the Omni 3200
Before processing transactions that require a receipt or record, you must install a
roll of thermal-sensitive paper in the printer.
/3210
terminals
SE
SE
SE
/3210
terminal.
SE
SE
/