Table of Contents
Advertisement
WARNING
Establish
Telephone Line
Connections
CAUTION
Direct Connection
Pass-Through
Connection
•
Two MOD10 modular jacks can be used to connect optional peripheral
devices.
•
Use the RS232 port, icon shown at right, to connect a VeriFone
CR 600 check reader or other peripheral device.
•
Use the bar code and PIN pad port, icons shown at right, to
connect a PIN pad, smart card reader, or bar code wand.
•
The power connection port uses a round barrel connector with a lock
notch (see
Figure
12) to securely connect the terminal to a power
source. This port is identified by the electrical power icon shown at
right.
Do not connect the terminal to the power supply until all the peripherals are
attached.
The Omni 3200
/3210
SE
two ways: direct or pass-through. The relative advantages and disadvantages of
these two types of telephone connections are described below.
Do not string the telephone cord across a walkway or place it so as to interfere in
high-traffic areas.
To reduce the risk of fire, use only No. 26AWG or larger telecommunication line
cord.
Connect the telephone cord to the communication port on the terminal, then route
it directly to a telephone wall jack (see
phone line is dedicated to the terminal, making it possible to perform an electronic
transaction at any time.
Figure 5
Direct Connection
Connect the telephone cord to the Telset port on the terminal, then route it to
RJ-11 jack on a standard telephone (see
connection, the telephone can be used when the terminal is not attempting to
perform a transaction.
terminal can be connected to a telephone line in one of
SE
Figure
5). With a direct connection, the
Figure
T
Establish Telephone Line Connections
6). With a pass-through
I
NSTALLATION
S
ERMINAL
ETUP
the
13
G
UIDE
Advertisement
Table of Contents
