Toshiba e-studio191f Service Manual page 62

2) When a DATA SD Card is installed
1. Before starting, print the F5/F6 Parameters List (Copy Service Mode F9-03-00).
2. Disconnect the Telephone Line, LAN and/or USB Cables.
3. Unplug the AC Power Cord to turn off power. (During a Lightning Storm, to prevent electrocution
disconnect the Telephone Line Cable first before unplugging the AC Power Cord.)
4. Remove the DATA SD Card from the machine.
5. Install the appropriate Master Firmware SD Memory Card into the machine.
6. Plug the AC Power Cord to turn on power.
7. Press the "Function", "Original Size", and the "3" keys sequentially.
8. Input the ID, and press the "Set" key to enter the Service Mode (default ID is 00000000).
9. Perform the Copy Service Mode F9-07-00 (Update From Master SD Card).
10. The firmware is copied into the machine.
Selecting the "Auto Mode", copies all the necessary firmware at once.
11. After the update is completed, the machine reboots itself and returns to standby.
12. Unplug the AC Power Cord to turn off power.
13. Remove the Master Firmware SD Memory Card from the machine.
14. Reinstall the DATA SD Card into the machine.
15. Plug the AC Power Cord to turn on power.
16. Reconnect the Telephone Line, LAN and/or USB Cables.
17. Reprogram the F5 & F6 Parameters according to the lists printed in Step 1. if the settings are other
than factory default.
Note:
After the update is completed, the machine reboots itself and returns to standby mode.
Selecting the "Auto Mode", prompts the unit to check the configuration and installed options, and all
the necessary firmware is updated automatically.
Confirm that the update was successfully completed by checking the Firmware Version with F9
Parameters F9-02-xx.
Caution:
If the unit does not boot up properly in Step 9., refer to 3.5.7. (Firmware Emergency Recovery)
3.5.5. Creating a Master Firmware SD Memory Card using a PC
1) Install the "SD Memory Card Firmware Writing Tool" to your PC.
The Tool can be downloaded from your sales company's Web Site. Please refer to the Tool's
Operating Instructions file for additional details.
2) Preparing the Firmware Code
Access the Service Web site to download the latest Firmware Code. When performing the
self-extraction wizard for preparing the Firmware Code File, the Archive will be extracted automatically
into the designated folder.
Example:
From:
Firmware Code File:
To:
Firmware Data Folder:
3) Preparing the Master Firmware SD Memory Card
1. Insert the SD Memory Card (32 MB to 2 GB) into the SD Memory Card Slot.
2. Perform the SD Memory Card Firmware Writing Tool.
3. After all firmware codes are copied, remove the SD Memory Card from the Slot.
The SD Memory Card is now ready to use for firmware update.
(Refer to the Local Firmware Update Tool OI and the SD Memory Card Firmware Writing Tool OI.)
UF-8200_UZ_xxxxxx.exe
C:\ Pcc \ Fup \ Data
62
DP-1910F