Installing The Sd Memory Card (32 Mb Up To 2 Gb) - Toshiba e-studio191f Service Manual

7.4.

Installing the SD Memory Card (32 MB up to 2 GB)

7.4.1. Contents
No. Qty.
1 1
7.4.2. Installation
CAUTION!
Unplug the AC Power Cord before beginning installation
Caution:
Do not remove the SD Memory Card or turn the power OFF during Formatting or while Updating the
Firmware.
Note:
1. When a New (Blank) SD Memory Card is detected for the first time, a prompt for Formatting will
appear on the LCD. The machine will format the SD Card for DATA (used for Fax Image, 1,000
Station Auto Dialer, JOB MIB Data, etc.), and it takes approximately 3 to 12 min. to format depending
on the manufacturer, SD Memory Card size or Data Access Speed of the SD Card.
2. To Update the Firmware or to Format an SD Memory Card using the F9-15 Service Mode takes
approximately 5 sec. Refer to 3.5.6. (Formatting the SD Memory Card).
Description
SD Memory Card
32 MB - 2 GB
SDHC / SDXC is not supported.
(1) Remove 1 Screw.
(2) Remove the SD Card Cover.
(3) Gently insert the SD Memory Card as illustrated
(Logo facing toward the rea of the machine).
Caution:
Forcing the card into the slot may cause damage to the
card or machine.
(4) Reinstall the SD Card Cover and 1 Screw.
(5) Plug the AC Power Cord first, then reconnect the
Telephone Line Cable.
(6) Reconnect the LAN / USB Cable(s) if disconnected.
203
DP-1910F
Remarks