Toshiba e-studio191f Service Manual page 133

Code Mode Phase
416 RCV
417 RCV
418 RCV
420 RCV
421 RCV
422 XMT
427 G3
RCV
434 XMT or
RCV
436 G3 RX
438 RCV
456 RCV
457 RELAY
XMT
CONF.
XMT/
POLL
459 RCV
490 RCV
494 RCV
495 XMT
RCV
496 XMT
Fax Information Codes
Description of Problem
D Receiver did not detect post
command, such as EOP, MPS, EOM,
etc.
C Receiver returned RTN in response to
post message.
C Receiver transmitted PIN in response
to PRI-Q from transmitter.
(Transmitting operator requests voice
contact)
B T1 timer (35 sec.) elapsed without
detecting 300 bps signal.
B Busy Tone is detected after sending
NSF Signal.
B Content of NSF (or DIS) or NSC (or
DTC) was invalid.
B DCN received to NSF/CSI/DIS
transmitted.
B CD (response from Modem) did not
turn OFF within 180 sec. after
receiver detected FLAG signal.
C DCN received after transmitting FTT.
B Refusal ID (Junk Fax ID) received in
Phase B.
B Received relay transfer request or
confidential document to distribute to
an end receiving station or all
confidential mailboxes are used.
B Remote unit does not have Relayed
XMT or Confidential Comm.
capability.
C Failed training in Phase C.
C Sum of error lines exceeded the limit
(Function Parameter No. 70) of 64
lines.
C Interval between two EOLs was more
than 10 sec. when receiver received
message data.
C During reception, CD turned OFF or
continued ON for long time. During
communication, lost loop - current.
C CS of modem is not able to turn ON.
Transmitter is defective.
Line quality is poor. (RTC signal is
distorted due to line noise)
SC PCB or FXB PCB is defective.
Line quality is poor. (There are
excessive errors in received data)
SC PCB or FXB PCB is defective.
Line quality is poor. (There are
excessive errors in received data)
SC PCB or FXB PCB is defective.
Incorrect incoming call type (voice).
(Non-facsimile communication)
Transmitter is defective.
SC PCB or FXB PCB is defective.
Remote station disconnected the line.
Wrong number is dialed.
There is an incompatibility.
The interface is incompatible.
Remote unit is defective.
SC PCB or FXB PCB is defective.
Transmitter is defective or incompatible.
Line quality is poor.
Transmitter ID is registered as a Junk
Fax. JUNK is printed as the Information
Code on the Comm. Journal.
Line quality is poor. (Training signal is
distorted due to line noise)
SC PCB or FXB PCB is defective.
Line quality is poor.
SC PCB or FXB PCB is defective.
Transmitter is defective.
Line quality is poor. (EOL is damaged
due to line noise)
SC PCB or FXB PCB is defective.
Line is disconnected.
Transmitter is defective.
SC PCB or FXB PCB is defective.
FXB PCB is defective.
133
DP-1910F
Cause