On/Off Of The Character Indication - Sony F35 Operation Manual

Setting Operation of the fans
AUTO1 (default) The fans are automatically controlled
according to the internal temperature.
During recording, the fans are
controlled for a quiet condition.
Normally use this mode.
AUTO2 The fans are normally controlled as
those in MIN mode and for a quieter
condition during recording. Note that
recording time must be limited to a short
duration. Use this mode only under
ordinary ambient temperature.
MIN The quietest fan operation is maintained
without synchronization with recording.
This is the best mode if recording must
be made for more than 30 minutes in a
quiet condition such as a concert hall.
Use this mode only under ordinary
ambient temperature.
MAX The fans rotate at the maximum speed
to lower the internal temperature.
Notes
• If the internal temperature rises so high that the
TEMPERATURE CARE message is displayed, the fan
rotation speed will automatically increase to lower the
temperature.
• If the internal temperature rises so high that the
TEMPERATURE WARNING message is displayed, the
Fan Operation mode setting is automatically changed to
MAX. After the temperature is sufficiently lowed and
the message disappears, manually restore the original
mode.
To change Fan Operation mode using the menu
You can also change Fan Operation mode (FAN MODE)
by using the <OTHERS 1> page on the USER
(MAINTENANCE) menu (page 82).
3-2-10 ON/OFF of the Character
Indication
Superimposition of character data onto camera images can
be activated or deactivated by output destination.
Character indication setting page
VF1:ON
MON:ON
VF1
Viewfinder connected via the VF1 connector (default: ON)
VF2
Viewfinder connected via the VF2 connector (default: ON)
VF2:ON
VBS:ON
MON
Monitors connected via the MONITOR OUT HD SDI
connectors (default: ON)
VBS
Monitors connected via the TEST OUT and REMOTE
connectors (default: ON)
3-2-11 Allocation of Functions to
the Assignable Buttons and Switch
Various functions can be allocated to assignable buttons 1
to 3 and assignable switch 4 (the upper position of the 4/
AUTO BLK BAL switch) that are located on the side of the
camera and on the assistant panel.
At shipment, no function is allocated to these buttons.
Functions that can be allocated to assignable
buttons 1 to 3
Menu Function
indication
ND Selection of the ND filter
REC REVIEW With REC REVIEW set to NORM on the
SRW-1, the last part of the recorded tape
is normally rewound for 3 seconds
(maximum: 10 seconds) then played
back.
With REC REVIEW set to ALL on the
SRW-1, the tape is rewound to the
recording start position then played back.
PB(VF) The video signals being played back on
the SRW-1 are output to the viewfinder.
VF709GAM ON/OFF of the fixed ITU-R709 gamma of
the viewfinder
MONI709GAM ON/OFF of the fixed ITU-R709 gamma of
the monitor
FAN MODE Switching of Fan Operation mode
GAIN –9/–18 dB If the picture becomes too bright when
you set the lens iris to its open end to
assist the focus adjustment, the electric
gain can be temporarily decreased to
resume the proper picture level by using
this function.
Each push on the assignable button
changes the setting in the sequence of
OFF, –9 dB, –18 dB, OFF, and so on.
Notes
• The gain-decreased condition is
automatically released in approx. 1
minute.
• Do not perform recording in the
condtion where the gain is decreased
with this function.
OFF None
Basic Settings with the Subdisplay
39