ZyXEL Communications VMG3925-B10A User Manual page 32

Connection Mode
Encapsulation
IPv6/IPv4 Mode
ATM PVC Configuration
VPI/VCI
Encapsulation Mode
Service Category
Account Information
PPP User Name
PPP Password
PPPoE Service Name
Static IP Address
Others
Enter the General and ATM PVC Configuration settings as provided above.
3
Set the Type to ADSL over ATM.
Choose the Encapsulation specified by your DSL service provider. For this example, the service
provider requires a username and password to establish Internet connection. Therefore, select
PPPoE as the WAN encapsulation type.
Set the IPv4/IPv6 Mode to IPv4 Only.
Enter the account information provided to you by your DSL service provider.
4
Configure this rule as your default Internet connection by selecting the Apply as Default Gateway
5
check box. Then select DNS as Static and enter the DNS server addresses provided to you, such as
192.168.5.2 (DNS server1)/192.168.5.1 (DNS server2).
Leave the rest of the fields to the default settings.
6
Click Apply to save your settings.
7
Chapter 4 Tutorials
Routing
PPPoE
IPv4
36/48
LLC/SNAP-Bridging
UBR without PCR
1234@DSL-Ex.com
ABCDEF!
MyDSL
192.168.1.32
Authentication Method: AUTO
PPPoE Passthrough: Disabled
NAT: Enabled
IGMP Multicast Proxy: Enabled
Apply as Default Gateway: Enabled
VLAN: Disabled
VMG3925-B10A User's Guide
32