Paper Size Not Detected; Insufficient Paper For Job - Canon IPF8400S Basic Manual

iPF8400S Basic Guide

Paper size not detected.

Paper has been loaded askew, or warped paper has been loaded.
Because the Platen is soiled with ink or other substances, the size of the clear
film cannot be detected.

Insufficient paper for job

The printer has received a print job longer than the amount of roll paper
left when ManageRemainRoll in the Control Panel menu is On.
136
Cause
Cause
Cause
Corrective Action
(See "Loading Rolls in the Printer.")➔P.14
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box
displayed when you select Fit Roll Paper Width in the
printer driver matches the width of the roll loaded in the
printer, and then try printing again.
Lift up the Release Lever and reload the
paper.
(See "Loading Rolls in the Printer.")➔
P.14
(See "Loading Sheets in the Printer.")➔
P.21
If Not finished printing. Finish
printing remaining jobs? is displayed
on the Display Screen, press the OK
button.
Printing will resume, starting from the
page on which the error occurred.
If this error recurs after you reload the
roll, remove the Roll Holder from the
printer, push the roll firmly in until it
touches the Roll Holder flange, and
reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to
Rolls.")➔P.12
Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cover.")
➔P.56
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough
Corrective Action
Corrective Action