How to connect your extended power cables
1. Prepare the following tools:
Tools
Spec
Shape
2. As shown in the figure, peel off the shields from the rubber and wire of the
power cable.
- Peel off 20 mm of the wire shields of the tube.
• After peeling off the tube wire, you must insert a contraction
tube.
CAUTION
• For information about the power cable specifications for
indoor and outdoor units, refer to the installation manual.
3. Insert both sides of core wire of the power cable into the connection sleeve.
f Method 1
f
Push the core wire in to the sleeve from both sides.
f Method 2
f
Twist the wire cores together and push it in to the sleeve.
50
Mirage_AP50M0@_IBIM_EN_05323A-02.indd 50
Crimping pliers
Connection sleeve (mm)
MH-14
20xØ6.5(HxOD)
Insulation tape
Contraction tube (mm)
Width 19 mm
70xØ8.0 (LxOD)
Power cable
20
20
120
180
Connection sleeve
Connection sleeve
2016-05-19 오후 1:27:30
20
60
(Unit: mm)