Drain hose
1. Connect the drain hose by inserting the extension
drain hose to the drain connection port tightly.
2. Insulate the extension drain hose, then fix it with a
cable tie or a tape.
Vinyl chloride
Piping material
(Inner diameter ø 13 mm)
Insulation
Foamed polyethylene
• As the draining is of natural drain type, make the drain hose direct downward.
• Fix the drain hose tightly to prevent any water leakage.
CAUTION
• If there is any foreign substance in the drain plate, it may clog the drain pipe. Therefore, be sure to remove the
foreign substance inside after installation.
• Do not extend the drain hose.
Fixing the indoor unit
f If the indoor unit is installed on unstable place, it may shake or fall down. To prevent these accidents, you must fix the top
f
of the indoor unit tightly with fixing brackets.
Wall installation
Example 1
Mirage_AP50M0@_IBIM_EN_05323A-02.indd 43
Drain hole for duct
(polypropylene)
Insulation (foamed
polyethylene)
Connecting drain hose
Corner Installation
Example 2
Drain hose
2016-05-19 오후 1:27:26
43