Table of Contents
Advertisement
How to connect your extended power cables
Items to prepare
(compressor and insulation tape should be prepared by an installation technician.)
Tools
Crimping pliers
Spec
MH-14
Shape
1. As shown in the figure, peel off the shields from the rubber/wire
of the power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
• A fter peeling off the tube wire, you must insert a contraction tube.
2. Insert both sides of core wire of the power cable into the connection sleeve.
3. Using a compressor, compress the two points and flip it over
and compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to
make sure it is firmly pressed.
4. Wrap it with the insulation tape twice and position your
contraction tube in the middle of the insulation tape.
5. Apply heat to the contraction tube to contract it.
6. After tube contraction work is completed, wrap it with the
insulation tape to finish.
• I n case of extending the electric wire, please DO NOT use a round-shaped pressing socket.
- Incomplete wire connections can cause electric shock or a fire.
NA_GOOD_A3050_IB&IM_EN_DB68-05202A-02.indd 54
Connection sleeve (mm)
Insulation tape
20xØ7.0(HxOD)
English-54
Contraction tube (mm)
Width 18 mm
50xØ8.0(LxOD)
Power cable (provided by us)
Wire tube power cable
Connection sleeve
(Unit: mm)
20
20
20
60
120
180
20
Comp. dim.
Compress it 4 times
5 mm
Insulation tape
40 mm
Contraction tube
Insulation tape
11/6/2015 2:33:39 PM
Advertisement
Table of Contents
