Table of Contents
Advertisement
How to connect your extended power cables
❋ ❋ Items to prepare (compressor and insulation tape should be prepared by an installation technician.)
Tools
Crimping plier
Spec
Shape
1. As shown in the figure, peel off the shields from the rubber/wire of the
power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
After peeling off the tube wire, you must insert a contraction tube.
CAUTION
2. Insert both sides of core wire of the power cable into the connection
sleeve.
3. Using a compressor, compress the two points and flip it over and
compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly
pressed.
4. Wrap it with the insulation tape twice and position your contraction tube
in the middle of the insulation tape.
5. Apply heat to the contraction tube to contract it.
6. After tube contraction work is completed, wrap it with the insulation tape
to finish.
In case of extending the electric wire, please DO NOT use a round-shaped pressing socket.
- Incomplete wire connections can cause electric shock or a fire.
WARNING
Mirage_AP30M0@_IBIM_E_34518A(1).indd 55
Connection sleeve (mm)
MH-14
20 x ø7.0(H x OD)
Insulation tape
Contraction tube (mm)
Width 18mm
50x ø8.0(LxOD)
Power cable (provided)
20
20
60
120
180
Wire tube power cable
20
Connection sleeve
Comp. dim.
Compress it 4 times
5mm
Insulation tape
40mm
Contraction tube
Insulation tape
(Unit: mm)
20
55
2012-02-01 오후 4:07:59
Advertisement
Table of Contents
