Table of Contents
Advertisement
Cool
In Cool mode, the air conditioner will cool your room. You can adjust the temperature and the fan speed to feel cooler in hot
season.
1. Turn on the air conditioner.
Press the Power
button on the remote controller.
2. Set the operation mode.
Press the Mode button on the remote controller until Cool mode
indicator appears on the remote controller display.
The air conditioner operates in Cool mode and it will lower the
temperature in your room.
Each time you press the Mode button, the mode will change
in order of Auto, Cool, Dry, Fan and Heat*. (*Heat mode is
NOTE
applicable for AP30M1✴ model only.)
3. Set the temperature.
Press the Temp + or - button on the remote controller to increase or
decrease the desired temperature.
You can set the desired temperature between the range of
18˚C~30˚C.
You can increase/decrease the temperature by 1˚C.
NOTE
4. Set the fan speed.
Press the Fan
or
desired fan speed.
If room temperature reaches desired value, the air conditioner will
shut off cooling for a while and just the fan runs.
Each time you press the Fan
change in order of Auto, Low, Medium and High.
NOTE
• While you are using the remote controller, make sure correct indicator which matches your selection appears on the
remote controller display.
NOTE
• Air flow can be adjusted manually (see page 20 for instructions).
• If current outside temperatures are much higher than the selected indoor temperature, it may take time to bring
the inner temperature to the desired coolness.
• If you operate the air conditioner right after stopping the cooling operation or the temperature reaches to the
desired temperature, cool air will not come out around 3 minutes for compressor protection.
Mirage_AP30M0@_IBIM_E_34518A(1).indd 13
button on the remote controller to set the
or
button, fan speed will
13
2012-02-01 오후 4:07:15
Advertisement
Table of Contents
