Table of Contents
Advertisement
Electrical wiring
f Connect it to the terminal board N and L for power cable to the outdoor unit. In so doing, peel off the end of the power
f
cord by about 5mm, and press the cord to the ring terminal for hooking.
- Make sure to install exclusive power supply. (If you use multiple connecting, there is a risk of electric shock or fire.)
- If the outdoor power supply has been selected, install circuit breaker(ELCB). (Purchase separately)
- Make sure to connect earth wire.
- Make sure that the clamping force of the screw (on the terminal) is tightened firmly within the range of rated
tightening torque.
- The appliance shall be installed in accordance with national wiring regulations for installation (SASO 2007:2002).
- Disconnection means must be incorporated in the fixed wiring in accordance with the wiring rules.
Connecting the power terminal
f Connect the cables to the terminal board using the compressed ring terminal.
f
f Use rated cables only and make sure to fix them without applying any external force to the terminal.
f
f Connect the cables with driver and wrench that can apply the rated torque to the screws.
f
f Make sure that appropriate tightening torque is applied for cable connection. If the terminal is loose, arc heat may occur
f
and cause fire and if the terminal is connected too firmly, terminal may get damaged.
Mirage_AP30M0@_IBIM_E_34518A(1).indd 43
Screw
M3
M3.5
M4
M5
M6
Tightening torque (kgf·cm)
5.0~6.0
8.0~10.0
12.0~15.0
20.0~25.0
25.0~30.0
2012-02-01 오후 4:07:48
43
Advertisement
Table of Contents
