Table of Contents
Advertisement
Outdoor
unit
4. Install the high pressure pipe to the heat exchanger liquid pipe, and the low pressure pipe to the heat exchanger gas pipe
respectively using the flare nut, taking care not to cause any leakage of refrigerant.
5. Be sure to insulate the pipe with appropriate insulation material.
6. Insert the extension drain hose to the drain connection port tightly, then fix them with a cable tie or a tape to prevent any
water leakage; see page 48.
7. After completion of the installation, check the connecting area for any gas leakage.
8. Wind a finish tape when the wiring of the refrigerant pipe, the unit, and the drain piping are completed.
9. Fix the piping and drain hose by using the indoor unit piping holder.
Indoor unit piping holder
Mirage_AP30M0@_IBIM_E_34518A(1).indd 45
Indoor unit
Outdoor
Indoor unit
Indoor unit checking area
Indoor unit
unit
Fix the pipe
Outdoor
unit
Outdoor unit
checking area
S-TRAP
Fix the pipe
(Every 6m)
45
2012-02-01 오후 4:07:50
Advertisement
Table of Contents
