Table of Contents
Advertisement
Operating basic function
Heat (Only applicable for AP30M1✴ model)
The air conditioner heats as well as cools. Warm your room with this versatile appliance in the cold of winter.
1. Turn on the air conditioner.
Press the Power
button on the remote controller.
2. Set the operating mode.
Press the Mode button on the remote controller until Heat mode
indicator appears on the remote controller display.
The air conditioner operates in Heat mode and warms your room.
Each time you press the Mode button, the mode will change in
order of Auto, Cool, Dry, Fan and Heat.
NOTE
3. Set the temperature.
Press the Temp + or – button on the remote control to increase or
decrease the desired temperature.
You can set the desired temperature between the range of
16˚C~30˚C.
You can increase/decrease the temperature by 1˚C.
NOTE
4. Set the fan speed.
Press the Fan
or
desired fan speed.
If room temperature reaches desired value, heating will stop for a
while.
• Each time you press the Fan
change in order of Auto, Low, Medium and High.
NOTE
• Fan may not operate for about 3~5 minutes at the beginning
to prevent any cold blasts while the air conditioner is warming
up.
• Air flow can be adjusted manually (see page 20 for instructions).
• Since the air conditioner heats the room by taking heat energy from outdoor air, the heating capacity may decrease
NOTE
when outdoor temperature is extremely low. Use an additional heating appliance in combination with the air
conditioner if you feel the air conditioner heats insufficiently.
• Frost may form in outdoor unit during Heat mode. Defrost indicator
when the outdoor unit starts removing frost and it will disappear when the operation is done.
16
Mirage_AP30M0@_IBIM_E_34518A(1).indd 16
button on the remote controller to set the
or
button, fan speed will
will light up on the indoor unit display
2012-02-01 오후 4:07:20
Advertisement
Table of Contents
