Fiberboard; Panels; Finish - England's Stove Works 25-IP Installation & Operation Manual

To remove the fiberboard:

Remove the air wash bar, located on top of the cradle.

Remove the burn pot.

5
Using a / " socket, remove the screw and washer that hold the fiberboard in place.
16

Remove the board by pulling one side out first.

Put new board in, using the reverse of the above. BE CAREFUL not to over-tighten the screw.
The panels are designed with venting holes to release some of the heat coming off the stove;
however, the panels will get hot during operation. DO NOT TOUCH THE SIDES OR THE FRONT PANEL
DURING OPERATION, OR WHILE SHUTTING /COOLING DOWN. EVEN AFTER THE STOVE HAS HAD
ENOUGH TIME TO COOL, USE CARE WHEN HANDLING THE SIDE/FRONT PANELS, AS THEY COULD
STILL BE HOT. The side panels on this unit are hinged and will swing open. You can open them to work
within the stove. To open a side panel, simply pull from the front side, in the middle of the panel. To
close the side panel, push it in at the top. There is a clip at the top and a magnet at the bottom.
This new unit has been painted with High-Temperature paint that should retain its original look for
years. If the unit should get wet and rust spots appear, the spots can be sanded with fine steel wool
and repainted. It is crucial that only High-Temperature Spray Paint is used (Part # AC-MBSP), as others
may not adhere to the surface or withstand the high temperatures. Similarly, some brands of paint will
not adhere to different brands of paint, so we highly recommend using our proprietary High-
Temperature Spray Paint.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING
THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT,
OR DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY

FIBERBOARD

PANELS

FINISH

43
QUESTIONS.