Table of Contents
Advertisement
Thermostat Installation
1. Unplug the unit and remove the back panel of the stove, using a
2. Locate the thermostat connect block, labeled J18, on the rear of the control board, near the
bottom (See image below and pg. 40 of this manual for a control board diagram). It will have a
small wire "jumper" installed in it from the factory. This jumper bypasses the thermostat and
should be saved.
3. Loosen the two screws using a small slotted "jewelers" screwdriver and remove the "jumper."
4. Insert the two thermostat wires in place of the "jumper" and retighten the screws.
5. Reinstall the back panel and mount the thermostat; the control board automatically reads the
thermostat and your stove is now ready for thermostat operation.
THERMOSTAT OPERATION: This stove is equipped with a unique, new feature that allows two options
for thermostatic operation: The stove comes from the factory pre-programmed in "On/Off mode," which
turns the stove on and off when the call for heat comes or leaves, like a furnace. The second, or
"High/Low mode," burns at whichever heat range you set the stove at until the call for heat leaves, at
which point the stove goes to the Low heat range setting.
To set the stove in the "High/Low mode," unplug the unit and plug it back in, then press and release both
down arrows; H L appears in the heat range and blower speed windows. The unit is now in "High/Low
mode." (Note: Repeat this to change back to "On/Off mode;" a 0 0 will appear in the heat range and
blower speed windows). Using a thermostat in On/Off mode may shorten the life of your stove's igniter.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING
THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT,
OR DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY
THERMOSTAT OPERATION
THERMOSTAT OPERATION
22
QUESTIONS.
5
/
" wrench.
16
Connect
thermostat
wires here
(J18)
Hide quick links:
Advertisement
Table of Contents
