Loading Paper Into Paper Trays - Ricoh SP 3600dn User Manual

Loading Paper into Paper Trays

In the following example procedure, paper is loaded into Tray 1.
• When loading paper, take care not to trap or injure your fingers.
• When using the envelope lever, take care not to trap or injure your fingers.
• For details about trays that can be loaded for each paper size and type, see page 26 "Paper Size
Specifications" and page 29 "Paper Type Specifications".
• Be sure to select the correct paper size and feed direction using the paper size dial on the tray.
Otherwise, the printer might be damaged, or printing problems might occur.
• Make sure the paper stack does not exceed the upper limit mark inside the paper tray. Excessive
stacking can cause paper jams.
• If paper jams occur frequently, flip the paper stack in the tray.
• Do not mix different types of paper in the same paper tray.
• After loading paper, specify the paper size using the control panel or paper size dial, and paper
type using the control panel. When printing a document, specify the same paper size and type in
the printer driver as specified on the printer.
• Do not move the side paper guides and end paper guide forcefully. Doing so may damage the
tray.
• When loading label paper, load it one by one.
• The envelope lever is kept down by the factory default. Before printing with paper, except for
envelopes, be sure to raise the envelope lever all the way up.
CYN916
Loading Paper into Paper Trays
33