Chapter 2 Hardware Installation; Installing Hard Drive & Dvd Burner; Installing Hard Drive; Installing A Dvd Burner - Q-See QSTD2404 User Manual

QSTD2400 Series DVR User's Manual
CHAPTER 2
Notice: Check the unit and the accessories after receiving the DVR.
Please disconnect the power before connecting other devices. Do not hot plug in/out
Notice: Some vendors sell this DVR as part of a package with a hard drive already installed.
If your unit already has a hard drive you can skip these steps unless you want to add additional
hard drives.
2.1 Installing Hard Drive & DVD Burner

2.1.1 Installing Hard Drive

Notice: 1. The DVR supports four SATA hard drives.
2. Please calculate HDD capacity according to the recording setting. For details,
please refer to "Appendix B Calculating Recording Capacity".
STEP1 Unscrew and Open the top cover
STEP2 Place HDD into the position shown as fig. 2.1
STEP3 Fix the HDD firmly with screws and then connect with data cables.
In addition, users can put a hard drive into HDD box shown below, if they do not
need to install a DVD burner.

2.1.2 Installing a DVD Burner

Notice: 1. The DVD burner should be one of the compatible devices we recommend. Please
refer to "Appendix C Compatible Devices"
2. This device is only for backup
STEP1 Unscrew and open the top cover
STEP2 Connect the power and data cables. Put DVD burner into the
position of CDROM. Some units ship with DVD burners pre-installed by the
factory.
:
Notice If users do not need to install DVD Burner, they can install a hard drive here as
following above instructions.
Hardware Installation
Fig 2.1 Installing hard drive
Fig. 2.2 Hard Drive Box
3