Hard Disk Drive; Installation/Removal - Q-See QT Series User Manual

Analog & sdi dvrs
Hide thumbs Also See for QT Series:
Table of Contents

Advertisement

HARD DISK DRIVE

Your DVR uses a standard desktop or 3.5" SATA (Serial Advanced Technology Attachment)
hard disk drive and will support drives up to 3TB (terabytes). These drives are the current
industry standard and may be purchased wherever computer parts are sold. Depending on
where you purchased your DVR, your hard drive may already be installed. But, we recognize
that you may wish to upgrade or replace your drive in the future so this DVR is designed
to make installation and replacement easy for the average user. An A/V-rated drive is
recommended for optimal performance.
It should be noted that while this is the only user-serviceable part within the case besides the
battery and you will not void your warranty by installing or upgrading your hard disk drive, care
must be taken to avoid damage to the other components within the case. Such damage will
not be covered.
The DVR MUST be unplugged from all power sources as well as from
the cameras before opening the case. Failure to do so can result in
damage to the DVR or its components as well as injury or death.

9.1 INSTALLATION/REMOVAL

It is strongly advised against opening the case when atmospheric conditions present the risk
of static discharge which can damage electronic components.
Whether installing the drive for the first time or removing the old one to install a new one, the
steps are largely the same:
STEP 1. Disconnect the DVR from the power source as well as any other connections.
STEP 2. Remove screws (the number will vary depending on your model) from the side
and rear of your DVR as indicated in
ALARM OUT
1
RS485
P/Z
K/B
Y
Z
A
B
1
3
2
4
ALARM OUT
STEP 3. Remove the case by sliding it
backwards and then lifting off.
STEP 3A. If removing a hard drive, you
will need to unscrew the four drive
mounting screws at the bottom of the
DVR or on the internal mounting rack.
WARNING! ELECTRIC SHOCK RISK!
Remove Screws
VIDEO OUT
2
3
4
ALARM IN
NET
5
7
9 11 13 15
VGA
SPOT
USB
6
8
10 12 14 16
Picture 9-1
1
3
5
7
2
4
6
8
VIDEO IN
PICTURE 9-1
9
11
13
15
DC 12V
10
12
14
16
Holes for
Holes for
Hard Disk Drive
Hard Disk Drive
Mounting Screws
Mounting Screws
PICTURE 9-2
CHAPTER 9
67

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents